2hp — Rout
Download the Rout Manual (PDF)
Rout (2hp) – Cheat Sheet
What is Rout?
- Voltage-controlled gate switch.
- Routes one gate/trigger input to any of four outputs.
- Selection via knob or CV input (0–5V).
- Perfect for splitting trigger/gate patterns to multiple voices or modulating patterns with a single gate source.
Panel Controls and I/O Reference
Inputs
| Jack/Control |
Label |
Function |
Voltage Range |
| 1 |
INPUT |
Main gate/trigger input to be routed |
Threshold: 2.5V |
| 2 |
SEL CV |
CV input to control output selection (overrides knob) |
0V – 5V |
Knobs
| Control |
Label |
Description |
| 3 |
SEL |
Manual selector for output (far left=OUT 1, far right=OUT 4). CV input overrides knob position. |
Outputs
| Jack |
Label |
Description |
Voltage Range |
| 5 |
OUT 1 |
Gate/trigger output if OUT 1 selected |
0V – 5V |
| 7 |
OUT 2 |
Gate/trigger output if OUT 2 selected |
0V – 5V |
| 9 |
OUT 3 |
Gate/trigger output if OUT 3 selected |
0V – 5V |
| 11 |
OUT 4 |
Gate/trigger output if OUT 4 selected |
0V – 5V |
LED Indicators
| LED |
Corresponds To |
Indicates |
| 4 |
OUT LED 1 |
Shows activity at OUT 1 |
| 6 |
OUT LED 2 |
Shows activity at OUT 2 |
| 8 |
OUT LED 3 |
Shows activity at OUT 3 |
| 10 |
OUT LED 4 |
Shows activity at OUT 4 |
Basic Operations
- Input your gate/trigger signal to INPUT.
- Select one of four outputs using the SEL knob (or use SEL CV for voltage control).
- Only one output is active at a time—the selected output passes the INPUT signal, others are low.
- Use the SEL CV input (0–5V) to automate output switching (e.g., from a sequencer, sample & hold, LFO, etc.).
- Monitor which output is active via the corresponding OUT LED.
Specs
- Width: 2 HP
- Depth: 47mm (Skiff friendly)
- Power: +12V = 26mA, -12V = 6mA
Generated With Eurorack Processor